LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2006 >> Sebring Limited, 2D Convertible >> Repair and Diagnosis >> Engine Performance >> System >> Emissions Control System >> Air Injection >> Mass Air Flow Sensor >> Removal
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Mass Air Flow Sensor: Removal

  1. Disconnect negative battery cable.
  2. Remove the air pump assembly, (Refer to EMISSIONS CONTROL/AIR INJECTION/PUMP - REMOVAL) .
  3. Remove 2 bracket mounting bolts. See Fig 1.
    Fig 1: Mounting Bracket Bolts
    GC0031941Courtesy of DAIMLERCHRYSLER CORP.
  4. Remove the bracket assembly. See Fig 2.
    Fig 2: Remove/Install Assembly
    GC0031943Courtesy of DAIMLERCHRYSLER CORP.
  5. Disconnect the electrical connector to MAF. See Fig 3.
    Fig 3: Mass Air Flow Sensor
    GC0031944Courtesy of DAIMLERCHRYSLER CORP.
    1 - Mass Air flow Sensor (MAF)
    2 - Relay
    2 - Inlet Filter
  6. Twist the MAF sideways and remove from bracket. See Fig 4.
    Fig 4: Removing/Installing Sensor From Bracket
    GC0031945Courtesy of DAIMLERCHRYSLER CORP.
  7. Remove the rubber mounting.
scientia non olet · About LEMON Manuals