2.4L Turbo

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Cable Retaining Clip

Courtesy of DAIMLERCHRYSLER CORP.

1 - HAIRPIN CLIP

Install the cable.
Install the retaining clip holding cable to servo. See Figure.

Fig 2: Vacuum And Electrical Connection At Servo
Courtesy of DAIMLERCHRYSLER CORP.

1 - Electrical Connector

2 - Vacuum Line and Nipple
Install the vacuum line to the speed control servo nipple. See Figure.
Connect and Lock the electrical connector to the speed control servo. See Figure.

Fig 3: Speed Control Servo - 2.4L Turbo
Courtesy of DAIMLERCHRYSLER CORP.
Install the speed control servo to the mounting bracket.
Install the 2 nuts to the speed control servo studs and tighten to 7 N.m (60 in. lbs.). See Figure.

Fig 4: Locating Retaining Tabs On Cables
Courtesy of DAIMLERCHRYSLER CORP.
Install speed control cable to throttle cable bracket. See Figure.
Install the speed control cable to the throttle body lever.

Fig 5: Throttle Control Shield
Courtesy of DAIMLERCHRYSLER CORP.
Install the throttle control shield. See Figure.

Fig 6: Removing/Installing Battery Negative Cable
Courtesy of DAIMLERCHRYSLER CORP.
Connect the negative battery cable.