Section 121 (Cruise Control Systems): Switch: Removal

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Speed Control Switch

Courtesy of DAIMLERCHRYSLER CORP.

The speed control switches is mounted in the steering wheel and wired through the clock spring device under the airbag module.

WARNING: If removal of airbag module is necessary, refer to the RESTRAINTS - SERVICE INFORMATION article.

Remove the air cleaner lid, disconnect the inlet air temperature sensor and makeup air hose.
Remove the negative battery cable.
Turn off ignition.
Remove air bag, refer to the RESTRAINTS - SERVICE INFORMATION article.
Remove the top mounting screw (1).

Fig 2: Speed Control Switch Fastener (Top Mounting Screw)
Courtesy of DAIMLERCHRYSLER CORP.

1 - TOP MOUNTING SCREW
Rotate steering wheel so that the switch is in the 6 o'clock position. Remove 2 screws from the back side of the speed control switch.

Fig 3: Removing/Installing - Speed Control Switch Positioning
Courtesy of DAIMLERCHRYSLER CORP.
Disconnect the electrical connector.
Remove switch.