Sensor-Oil Pressure: Installation

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Apply Mopar® Thread Sealant with PTFE to the sensor threads before installing into the engine block.

Install the oil pressure sensor (1).

Courtesy of DAIMLERCHRYSLER CORP.
Connect the oil pressure sensor electrical connector (1).

Courtesy of DAIMLERCHRYSLER CORP.
Position the generator and install the upper mounting bolt finger tight.
Raise and support the vehicle.
Install the lower mounting bolts (1) and tighten to 55 N.m (41 ft. lbs).

Courtesy of DAIMLERCHRYSLER CORP.
Position the lower splash shield and install the retaining bolts (1).

Courtesy of DAIMLERCHRYSLER CORP.
Lower the vehicle
Raise and support the vehicle.
CAUTION: When installing a serpentine accessory drive belt, the belt MUST be routed correctly. The water pump may be rotating in the wrong direction if the belt is installed incorrectly, causing the engine to overheat.
Install the accessory drive belt (Refer to DRIVE BELT )
Connect the negative battery cable.