Cable-Speed Control - 2.4L Turbo

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Throttle Control Shield - 2.4L Turbo

Courtesy of CHRYSLER LLC

Disconnect the negative battery cable.
Remove the throttle control shield. See Fig 1.

Fig 2: Locating Retaining Tabs On Cables
Courtesy of CHRYSLER LLC
Remove the speed control cable from the throttle body lever.
Remove from throttle cable bracket by compressing the retaining tabs on the cable and slide cable out of the bracket. See Fig 2.

Fig 3: Servo Vacuum & Electrical Connections
Courtesy of CHRYSLER LLC

1 - Electrical Connector

2 - Vacuum Line and Nipple
Remove the vacuum line from the speed control servo.

Fig 4: Speed Control Servo - 2.4L Turbo
Courtesy of CHRYSLER LLC
Remove the 2 nuts from the speed control servo studs. See Fig 4.

Fig 5: Cable Retaining Clip
Courtesy of CHRYSLER LLC

1 - HAIRPIN CLIP
Push and pull up the speed control servo from the mounting bracket.
Unlock and disconnect the electrical connector from the speed control servo. See Fig 3.
Remove the 2 push clips and discard.
Remove the retaining clip holding cable to servo. See Fig 5.
Remove the cable.