Speed Control Servo - 2.4L Turbo

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Battery Negative Cable

Courtesy of CHRYSLER LLC

Disconnect the negative battery cable.

Fig 2: Throttle Control Shield - 2.4L Turbo
Courtesy of CHRYSLER LLC
Remove the throttle control shield. See Fig 2.
Remove the speed control cable from the throttle body lever.
Remove the vacuum line from the speed control servo. See Fig 3.

Fig 3: Speed Control Servo - 2.4L Turbo
Courtesy of CHRYSLER LLC
Remove the 2 nuts from the speed control servo studs. See Figure.
Push and pull up the speed control servo from the mounting bracket.
Unlock and disconnect the electrical connector from the speed control servo. See Figure.
Remove the 2 push clips and discard.

Fig 4: Cable Retaining Clip
Courtesy of CHRYSLER LLC

1 - HAIRPIN CLIP
Remove the retaining clip (1) holding cable to servo. See Fig 4.