Section 22 (Ignition System (Service Information)): Plug-Spark: Installation: 2.7L
WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- To avoid cross threading, start the spark plug into the cylinder head by hand.
- Tighten spark plugs. Tighten to 17 N.m (12.5 ft. lbs.).
- Install ignition coil assembly onto spark plug.
- Hand tighten coil screws.
- Tighten ignition coil screws to 6.7 N.m (60 in. lbs.).
- Connect and lock the electrical connector.
- Install the intake manifold, (Refer to ENGINE/MANIFOLDS/INTAKE MANIFOLD - INSTALLATION)
- Connect the negative battery cable.