Section 22 (Ignition System (Service Information)): Sensor-Knock: Installation: 3.5L

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Knock Sensor

Courtesy of DAIMLERCHRYSLER CORP.

Install knock sensor. Tighten knock sensor to 20 N.m (15.2 in. lbs.) torque. Over or under tightening effects knock sensor performance, possibly causing improper spark control.

Fig 2: Routing Knock Sensor Wire
Courtesy of DAIMLERCHRYSLER CORP.
Route the knock sensor wire in the proper location.
Install the intake manifold, (Refer to ENGINE/MANIFOLDS/INTAKE MANIFOLD - INSTALLATION) .

Fig 3: Locating Electrical Connector
Courtesy of DAIMLERCHRYSLER CORP.
Connect electrical connector. See Fig 3.
Connect negative battery cable.