Sensor - Map - 3.8L

Fig 1: MAP Sensor 3.8L

Courtesy of CHRYSLER LLC

NOTE: Located on the intake manifold is a tab the prevents the manifold absolute pressure (MAP) sensor from being incorrectly installed. Seat the sensor by turning the sensor until the sensor contacts the tab on the intake manifold.

Install the MAP sensor (1) to the intake manifold (3) by turning the sensor 1/4 turn in the clockwise direction.
Connect the electrical connector (2) to the sensor (1).
Connect negative battery cable, tighten nut to 5 N.m (45 in. lbs.).