LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2008 >> Sebring Base, 2D Convertible, 2.4 K >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Electronic Control Modules (Service Information)) >> Electronic Control Modules - Service Information >> Module-Body Control >> Removal >> Module-Body Control
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module-Body Control

WARNING: This page is about a different car, the 2008 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: BCM Mounting
GC0000013Courtesy of CHRYSLER LLC
CAUTION: Do not swap BCM's between vehicles or with BCM's that are in stock.
NOTE: If the BCM is replaced, it must be programmed using a scan tool and DealerCONNECT®.
  1. Disconnect and isolate the battery negative cable.
  2. Remove the lower instrument panel silencer.
  3. Remove the knee blocker airbag. Refer to REMOVAL .
  4. Disconnect the 72-way bulkhead connector from the Body Control Module (BCM) (4) mounting assembly.
  5. Move bulkhead wiring aside.
  6. Disconnect the five wire connectors from the BCM.
  7. Remove the four screws (2) holding the BCM to the bulkhead.
  8. Remove the BCM from the mounting bracket.
scientia non olet · About LEMON Manuals