Remote Start Antenna - Installation

INSTALLATION






NOTE: Make sure the remote start antenna is positioned the same way noted during the removal procedure.

1. Install the remote start antenna module (2), and screws (1) to instrument panel assembly. Tighten screws to 2.5 Nm (22 in. lbs.).
2. Install the glove box, Instrument Panel Glove Box - Installation.





3. Route the remote start coaxial cable (1) in the position noted during the removal procedure.
4. Install the remote start antenna coaxial cable to mounting clips, if equipped.





5. Connect remote start antenna coaxial cable connector (1) to wireless ignition node (WIN) (2).
6. Install WIN to instrument panel bracket, Wireless Ignition Node Receiver - Installation.