Charging System (Service Information): Generator: Removal: 2.0L/2.4L

Fig 1: LOWER AIR DAM

Courtesy of CHRYSLER LLC

Disconnect and isolate negative battery cable at battery.
Remove the right front wheel.
Remove the underbody air dam.

Fig 2: IDLER PULLEY LOCATION
Courtesy of CHRYSLER LLC
Remove the accessory drive splash shield.
Remove the serpentine belt. Refer to Cooling/Accessory Drive/BELT, Serpentine - Removal .

Fig 3: IDLER PULLEY REMOVAL/INSTALL
Courtesy of CHRYSLER LLC
Remove the accessory drive idler pulley.

Fig 4: LOWER MOUNTING BOLT LOOSE
Courtesy of CHRYSLER LLC
Loosen the lower mounting bolt.

Fig 5: A/C COMPRESSOR RELOCATION
Courtesy of CHRYSLER LLC
Loosen the A/C compressor and relocate, pull down and to outboard side of vehicle to make room to remove generator.

Fig 6: FIELD CONNECTION
Courtesy of CHRYSLER LLC
Unplug field circuit from generator.

Fig 7: BATTERY CABLE CONNECTION
Courtesy of CHRYSLER LLC
Remove the B+ terminal nut and wire.

Fig 8: UPPER MOUNTING BOLT
Courtesy of CHRYSLER LLC
Remove the upper mounting bolt.
Remove the generator lower mounting bolt.

Fig 9: BATTERY STUD LOCATION
Courtesy of CHRYSLER LLC
Relocate the battery terminal (1) to the other side of the A/C line (2) for removal of the generator.

Fig 10: ROTATE GENERATOR
Courtesy of CHRYSLER LLC
Rotate generator pulley down.

Fig 11: Removing/Installing Generator
Courtesy of CHRYSLER LLC
Slide generator down and out of vehicle.