Section 2 (Engine Controls - System/Component Tests): Introduction
WARNING: This page is about a different car, the 1990 Daihatsu Rocky and 1990 Daihatsu Charade. However, it is still accessible from the selected car via links, so may be relevant.
Before testing separate components or systems, perform procedures in the BASIC TESTING article. Since many computer-controlled and monitored components set a trouble code if they malfunction, also perform procedures in TESTS W/CODES article.
NOTE:
Perform all voltage tests with a Digital Volt-Ohmmeter (DVOM) with a minimum 10-megohm input impedance, unless stated otherwise in test procedure. Testing individual components does not isolate shorts or opens. Use ohmmeter to isolate wiring harness shorts or opens.