LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 1984 >> Diplomat SE >> Repair and Diagnosis >> Engine Performance >> System >> 5.2L EFC System >> Testing >> Electronic Fuel Control System Tests >> Electronic Fuel Control Computer Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Electronic Fuel Control Computer Test

  1. Connect a tachometer and set parking brake. Start engine, warm to normal operating temperature and maintain engine speed of 1500 RPM. DO NOT  ground carburetor switch. Connect a voltmeter to duty cycle solenoid output wire going to carburetor (Green wire).
    NOTE: DO NOT  separate the solenoid connector from the wiring harness.
  2. Disconnect electrical connector at oxygen sensor and connect a jumper to a good ground. Engine speed should increase at least 50 RPM and voltmeter should indicate more than 9 volts.
  3. Hold the jumper wire with 1 hand and with the other hand, touch the battery positive terminal with the jumper wire. Engine speed should decrease at least 50 RPM and voltmeter should indicate less than 3 volts. If computer fails both tests, replace it. Reconnect oxygen sensor harness.
CAUTION: Before performing the next test, the fuel control computer must be operating properly.
scientia non olet · About LEMON Manuals