LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 1985 >> Caravan Base, 2.6 G >> Repair and Diagnosis >> Engine Performance >> System >> 2.2L EFC System >> Testing >> Checking Diagnostic System For Fault Codes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Checking Diagnostic System For Fault Codes

  1. Connect diagnostic readout box to engine harness connector. Put system into "Diagnostic Mode". Record all codes.
    NOTE: If fault codes 22, 28, 25 or 26 are stored, proceed to test indication.
  2. Turn ignition switch off. Disconnect computer 14-wire connector for 1 minute, then reconnect it. Start engine and run for 2 minutes. Turn engine off. Put system into "Diagnostic Mode". Record all codes.
  3. If same code appears before and after engine is started, problem still exists. Proceed to test indications. If a code does not reappear after engine is run and turned off, code no longer exists (was intermittent). Check for loose or corroded wiring connections in circuit. Use wiring diagram as a guide.
scientia non olet · About LEMON Manuals