No Code 88
- Disconnect diagnostic readout box from harness connector. Connect voltmeter between cavity No. 4 of engine harness connector and ground. Turn ignition switch to "RUN" position. Voltmeter should read 4-5 volts. Go to step 2). If voltage is not okay, go to step 2).
- Turn ignition switch off. Disconnect 14-wire connector from computer. Connect ohmmeter between cavity No. 2 of engine harness diagnostic connector and cavity No. 14 of computer 14-wire connector. If ohmmeter shows continuity, replace computer. If no continuity, inspect wire from cavity No. 14 to harness connector for open and repair.
- Disconnect diagnostic readout box. Turn ignition switch off. Disconnect 14-wire connector from computer. Connect ohmmeter between cavity No. 4 of engine harness connector and cavity No. 1 of computer 14-wire connector. If ohmmeter shows continuity, replace computer. If no continuity, inspect wire from cavity No. 1 to engine harness for an open circuit and repair.