Trouble Shooting: Notes
When a fault code is indicated (either by flashing check engine light or by diagnostic readout tool), SMEC has recognized an abnormal signal in the system. Fault codes indicate the result a failure in the fuel delivey system. The following fault codes can be set by SMEC:
- Code 88-Start of test.
- Code 11-Engine not cranked since battery was last disconnected.
- Code 12-Memory standby power lost.
- Code 13-MAP sensor pneumatic circuit.
- Code 14-MAP sensor electrical circuit.
- Code 15-Vehicle distance sensor.
- Code 16-Loss of battery voltage sense.
- Code 17-Engine operating temperature too low.
- Code 21-Oxygen sensor circuit.
- Code 22-Coolant temperature sensor circuit.
- Code 23-Throttle body temperature sensor circuit.
- Code 24-Throttle position sensor circuit.
- Code 25-AIS motor driver circuit.
- Code 26-Peak injector current not being reached.
- Code 27-Fuel injector control problem.
- Code 31-Purge solenoid circuit.
- Code 33-A/C cutout relay circuit.
- Code 34-Speed control solenoid driver circuit.
- Code 35-Fan control relay circuit.
- Code 41-Charging system excess or no field circuit.
- Code 42-Auto shutdown relay driver.
- Code 43-Spark interface circuit.
- Code 44-Loss of FJ2 to logic board.
- Code 46-Battery voltage too high.
- Code 47-Battery voltage too low.
- Code 51-Lean condition indicated.
- Code 52-Rich condition indicated.
- Code 53-Internal logic module problem.
- Code 55-End of message.