Camshaft Angle Sensor (3.3L): Installation

If removed sensor is to be reinstalled, clean off old spacer on sensor face. A new spacer MUST be attached to face before installation. Inspect "O" ring for damage and replace if necessary.
If sensor is being replaced, confirm that paper spacer is attached to sensor face and that "O" ring is positioned in groove of new sensor. Apply a couple drops of clean engine oil to "O" ring prior to installation.
Install sensor in chain case cover. Push sensor down until contact is made with cam timing gear. Hold sensor in this position and tighten retaining bolt to 105 INCH lbs. (11.9 N.m).
Connect sensor lead wire at wiring harness connector. Position lead wire to keep it away from accessory belt.