LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 1990 >> Caravan Base, 2.5 J, Standard >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Removal & Installation >> Distributor (3.0L Optical) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Distributor (3.0L Optical): Installation

  1. Position distributor in engine. Make certain that "O" ring is properly seated on distributor. Replace "O" ring if it is cracked or nicked.
  2. Carefully engage distributor drive with cam shaft drive so that when distributor is installed properly, rotor will be in line with previously scribed line on intake plenum.
  3. Install distributor cap. Check all high tension wires for good connection. Install hold-down nut and finger tighten. Connect distributor lead wire at wiring harness connector. Set ignition timing.
scientia non olet · About LEMON Manuals