Fuel Injector (2.5L TBI Models): Installation
- Place new "O" ring on injector cap. New injector will have new upper and lower "O" ring already installed. Apply a light coating of clean engine oil on "O" rings.
- Place assembly in pod and align injector wiring terminals with injector cap fastener hole. See Fig 1. Install injector cap with locating notch aligned with locating lobe on injector.
Courtesy of DAIMLERCHRYSLER CORP.
- Push down on cap to ensure a good seal. Rotate cap and injector to line up attachment hole. Install Torx screw and tighten to 35-45 INCH lbs. (4-5 N.m).
- Reconnect negative battery cable. Pressure test system for leaks. Reinstall air cleaner assembly.