LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 1992 >> Caravan Base, 2.5 K, Standard >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul - Gasoline >> Ignition System >> Camshaft Angle Sensor (3.3L) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Camshaft Angle Sensor (3.3L): Installation

  1. If reinstalling removed CAS, clean off old spacer from CAS face. A new spacer must be attached to face before installation. Inspect "O" ring for damage and replace if necessary.
  2. If replacing CAS, ensure paper spacer is attached to CAS face and "O" ring is positioned in groove of new CAS. Apply a couple drops of clean engine oil to "O" ring before installation.
  3. Install CAS in chain case cover. Push CAS down until it contacts cam timing gear. Hold CAS in this position, and tighten retaining bolt to 105 INCH lbs. (12 N.m).
  4. Connect CAS lead wire at wiring harness connector. Position lead wire away from accessory belt.
scientia non olet · About LEMON Manuals