LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 1992 >> Caravan Base, 2.5 K, Standard >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul - Gasoline >> Ignition System >> Distributor (3.9L & 5.2) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Distributor (3.9L & 5.2): Installation

  1. With engine at TDC, position distributor in engine. Ensure mounting base is free of debris. Ensure "O" ring is properly seated on distributor. Replace "O" ring if it is cracked or nicked.
  2. Carefully engage distributor drive with camshaft drive so when distributor is installed properly, rotor aligns with reference mark on distributor body.
  3. Install and finger-tighten hold-down nut. Install distributor cap. Check all high tension wires for good connections. Connect distributor lead wire at wiring harness connector. Set ignition timing. Tighten hold-down nut.
scientia non olet · About LEMON Manuals