LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 1992 >> Caravan Base, 2.5 K, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - Body Control Computer >> Self-Diagnostic Tests >> Test 5 - Identifying Chime Problem >> TEST 5A - Identifying Chime Problem
April 5, 2026: LEMON Manuals is launched! Read the announcement.

TEST 5A - Identifying Chime Problem

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For appropriate wiring diagram, see WIRING DIAGRAMS .
  1. Close all doors. If a speedometer problem exists, perform TEST 24A  for Electronic Cluster or TEST 30A for Electro/Mechanical Cluster. If no speedometer problem exists, turn ignition switch to ON position. Using DRB-II actuate chime test.
  2. If chime does not sound, replace body controller. Perform VERIFICATION TEST - VERIFICATION OF REPAIRS . If chime sounds, stop chime test using DRB-II. Open left front door. Turn ignition switch to OFF position, remove key from ignition switch and then wait 30 seconds. Using DRB-II, read key-in-ignition switch status.
  3. If DRB-II displays NO RESPONSE, perform TEST 44C . If DRB-II displays CIRCUIT CLOSED, perform TEST 5B. If DRB-II does not display NO RESPONSE or CIRCUIT CLOSED, place key in ignition switch. If chime does not sound, perform TEST 5B . If chime sounds, turn ignition switch to ON position.
  4. Check turn signals for proper operation. If turn signals do not operate properly, repair turn signal circuit as necessary. If turn signals operate properly, turn left signal on. Using DRB-II, read left turn signal status. If DRB-II does not display OPEN and then CLOSE, perform TEST 5C.
  5. If DRB-II displays OPEN and then CLOSE, turn right turn signal on. Using DRB-II, read right turn signal status. If DRB-II does not display OPEN and then CLOSE, perform TEST 5D. If DRB-II displays OPEN and then CLOSE, perform TEST 28A.
scientia non olet · About LEMON Manuals