TEST 9A - Diagnosing Estimated Time (ET) Function-Compass/Mini-Trip Module

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For appropriate wiring diagram, see WIRING DIAGRAMS .

Turn ignition switch to OFF position. Disconnect body controller Blue connector. Body controller is located under left side of instrument panel. Check connector, and clean or repair connector as necessary. Turn ignition switch to ON position. Put DRB-II in voltmeter mode.
Probe terminal No. 6 (Dark Blue/White wire) of body controller Blue connector. If voltage is more than 10 volts, replace body controller. Perform VERIFICATION TEST - VERIFICATION OF REPAIRS . If voltage is less than 10 volts, repair open Dark Blue/White wire. Perform VERIFICATION TEST - VERIFICATION OF REPAIRS .