Test 37B - Checking For Short In Seat Belt Warning Light Circuit
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagrams, see WIRING DIAGRAMS
article in the ENGINE PERFORMANCE Section. Perform TEST VER - 1A after each repair.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
- Turn ignition switch to OFF position. Disconnect Blue body controller connector. Body controller is located under left side of instrument panel. Check connector, and clean or repair connector as necessary.
- Turn ignition switch to ON position. If seat belt warning light is off, replace body controller. If seat belt warning light is on, repair short to ground in seat belt switch output circuit (Dark Blue/Red wire).