Test 8D - Repairing Open In Pod Switch Control Circuits
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagrams, see WIRING DIAGRAMS
article in the ENGINE PERFORMANCE Section. Perform TEST VER - 1A after each repair.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
- Disconnect both left pod switch connectors. Disconnect Natural body controller connector. Body controller is located under left side of instrument panel. Check connector, and clean or repair connector as necessary.
- Using an external ohmmeter, measure resistance of dimming level sense circuit between Black left pod switch connector terminal No. 1 (Orange/Black wire) and Natural body controller connector terminal No. 20. If resistance is more than 5 ohms, repair open in Orange/Black wire. If resistance is less than 5 ohms, go to next step.
- Using DRB-II in ohmmeter mode, measure resistance of system ground in Gray left pod switch connector terminal No. 1 (Black wire). If resistance is more than 5 ohms, repair open in Black wire.
- If resistance is less than 5 ohms, measure resistance of system ground in Black left pod switch connector terminal No. 6 (Black wire). If resistance is more than 5 ohms, repair open in Black wire. If resistance is less than 5 ohms, replace body controller.