Test 12B - Identifying Faulty Warning Light On Base Electro/Mechanical Instrument Cluster

NOTE: For wiring diagrams, see WIRING DIAGRAMS article in the ENGINE PERFORMANCE Section. Perform TEST VER-1A after each repair.

CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.

While observing oil warning light, start engine. If oil light stays on, go to TEST 47A. If oil warning light stays off, go to TEST 12C. If oil warning light comes on and then goes out when engine starts, go to next step.

If CHECK GAUGES light is on at all times, go to TEST 12D. If CHECK GAUGES light is not on at all times, actuate sequential light test using DRB-II. If sequential light test did not pass, stop actuation of sequential light test and go to TEST 12C. If sequential light test passed, stop actuation of sequential light test, identify faulty warning light, and perform test as indicated. See WARNING LIGHT TEST DIRECTORY table.

WARNING LIGHT TEST DIRECTORY

Defective Warning Light

Perform TEST

CHECK ENGINE

⁽¹⁾ *

Door Ajar

13A

Liftgate Ajar

43A

Low Fuel

⁽²⁾ *

Low Washer Fluid

44A

Voltage (Battery Symbol)

14A

⁽¹⁾	See appropriate G - TESTS W/ CODES article.

⁽²⁾	Go to step 3).

Ensure gas tank has more than 3 gallons in it. If fuel light is not on at all times, replace body controller. If fuel light is on at all times, turn ignition off and disconnect body controller connectors. Turn ignition on. If fuel light is still on, replace MIC. If fuel light is off, replace body controller.