Test 1A - Identifying Vehicle Equipment & System Problems
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagrams, see WIRING DIAGRAMS
article in the ENGINE PERFORMANCE Section. When directed to go to next step, disregard step if vehicle is not equipped with module being tested.
- Connect DRB-II to Chrysler Collision Detection (CCD) data link connector. Turn ignition switch to ON position. Using DRB-II, select BODY SYSTEM.
- If DRB-II does not display BUS OPERATIONAL, see VEHICLE COMMUNICATIONS. If DRB-II displays BUS OPERATIONAL, go to next step.
- If vehicle is equipped with a Mechanical Instrument Cluster (MIC), go to next step. Using DRB-II, select Electronic Instrument Cluster (EIC). If DRB-II displays NO RESPONSE, go to TEST 48A. If DRB-II does not display NO RESPONSE, go to step 5).
- Using DRB-II, select Mechanical Instrument Cluster (MIC). If DRB-II displays NO RESPONSE, replace body controller. If DRB-II does not display NO RESPONSE, go to next step.
- Using DRB-II, select body controller. If DRB-II displays NO RESPONSE, go to TEST 49A. If DRB-II does not display NO RESPONSE, go to next step.
- Using DRB-II, select compass mini-trip module (if equipped). If DRB-II displays NO RESPONSE, go to TEST 50A. If DRB-II does not display NO RESPONSE, see DIAGNOSTIC TEST DIRECTORY table for specific diagnosis.
DIAGNOSTIC TEST DIRECTORY
| Problem/Message | Perform TEST | ||
|---|---|---|---|
| Electronic Instrument Cluster | 2A | ||
| Electro/Mechanical Instrument Cluster | 9A | ||
| Compass/Mini-Trip Module | 15A | ||
| Power Door Lock System | 19 | ||
| Side Door Memory Lock | 21A | ||
| Windshield Wiper System | 22 | ||
| Illuminated Entry System | 25A | ||
| Courtesy Light System | 28 | ||
| Key-In Light | 33A | ||
| Headlights Will Not Turn Off | 34A | ||
| Headlight Time Delay Inoperative | 35A | ||
| Liftgate Release | 36A | ||
| Seat Belt Light | 37A | ||
| Chime Function | 38A | ||
|
|||