Test 35A - Headlight Time Delay Inoperative
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagrams, see WIRING DIAGRAMS
article in the ENGINE PERFORMANCE Section. Perform TEST VER - 1A after each repair.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
NOTE:
This test is for vehicles equipped with compass/mini-trip computer.
- Turn ignition switch to ON position. Turn low beam headlights on. If park and headlights do not operate properly by headlight switch, check headlight switch circuit and repair as necessary.
- If park and headlights operate properly by headlight switch, turn ignition switch to OFF position. Turn headlights off. If headlights remain on for 60 seconds and then go off, headlight time delay circuit is operational and system should be retested.
- If headlights do not remain on for 60 seconds and then go off, disconnect Natural body controller connector. Body controller is located under left side of instrument panel. Check connector, and clean or repair connector as necessary.
- Connect a jumper wire between Natural body controller connector terminal No. 15 (Orange/White wire). Check headlights. If headlights are off, repair open Orange/White wire. If headlights are on, replace body controller.