Test 49C - Repairing Body Controller Battery Power Supply
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagrams, see WIRING DIAGRAMS
article in the ENGINE PERFORMANCE Section. Perform TEST VER - 1A after each repair.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
- Ensure all courtesy lights are off. Reconnect Blue body controller connector. Close all doors. Using DRB-II in ohmmeter mode, check resistance of fused battery feed circuit at fuse No. 3 (Pink wire). If resistance is more than 5 ohms, replace fuse No. 3.
- If resistance is less than 5 ohms, disconnect left pod switch connector. Check resistance of fused battery feed circuit at fuse No. 3 (Pink wire). If resistance is more than 5 ohms, go to step 4).
- If resistance is less than 5 ohms, check resistance of switched battery feed circuit at left pod switch Black connector terminal No. 5 (Pink/Light Blue wire). If resistance is less than 5 ohms, repair short to ground in Pink/Light Blue wire and replace fuse No 3. If resistance is more than 5 ohms, repair short to ground in Pink wire and replace fuse No. 3.
- Disconnect Blue body controller connector. Check resistance of fused battery feed circuit at fuse No. 3 (Pink wire). If resistance is more than 5 ohms, replace body controller and fuse No. 3.
- If resistance is less than 5 ohms, disconnect instrument cluster connector. Check resistance of fused battery feed circuit at fuse No. 3 (Pink wire). If resistance is more than 5 ohms, replace instrument cluster and fuse No. 3.
- If resistance is less than 5 ohms, disconnect radio. Check resistance of fused battery feed circuit at fuse No. 3 (Pink wire). If resistance is more than 5 ohms, replace radio and fuse No. 3.
- If resistance is less than 5 ohms and vehicle is not equipped with compass/mini trip module, repair short to ground in Pink wire. If resistance is less than 5 ohms and vehicle is equipped with compass/mini trip module, disconnect compass/mini trip module 4-pin connector.
- Check resistance of fused battery feed circuit at fuse No. 3 (Pink wire). If resistance is more than 5 ohms, replace courtesy light assembly in overhead console and fuse No. 3.
- If resistance is less than 5 ohms, disconnect compass/mini trip module 13-pin connector. Check resistance of fused battery feed circuit at fuse No. 3 (Pink wire). If resistance is more than 5 ohms, replace compass/mini trip module and fuse No. 3. If resistance is less than 5 ohms, repair short to ground in Pink wire and replace fuse No. 3.