Test 8E - Repairing Short To Ground In Panel Lights Feed Circuit
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagrams, see WIRING DIAGRAMS
article in the ENGINE PERFORMANCE Section. Perform TEST VER - 1A after each repair.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
- Turn ignition switch to OFF position. Disconnect left pod switch. Remove park light relay from power distribution center. Remove fuse No. 9 from fuse block. Place DRB-II in ohmmeter mode. Measure resistance of output circuit at park light relay connector Black/Yellow wire.
- If resistance is less than 5 ohms, repair short to ground in Black/Yellow wire and replace fuse No. 22. If resistance is more than 5 ohms, measure resistance of control circuit at park light relay connector Brown/Orange wire.
- If resistance is less than 5 ohms, repair short to ground in Brown/Orange wire and replace fuse No. 22. If resistance is more than 5 ohms, measure resistance of fused battery feed circuit at park light relay connector Pink/Red wire.
- If resistance is less than 5 ohms, repair short to ground in Pink/Red wire and replace fuse No. 22. If resistance is more than 5 ohms, replace fuse No. 22.