LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 1993 >> Intrepid Base, 3.3 T >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - Body Control Computer >> Connector Identification >> Test 26C - Wiper Motor Output Circuit Short
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test 26C - Wiper Motor Output Circuit Short

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  . For appropriate wiring diagram, see WIRING DIAGRAMS  at end of article.
  1. Remove on/off wiper motor relay and high/low wiper motor relay from Power Distribution Center (PDC). PDC is located on left front fender apron. With DRB-II in ohmmeter mode, check resistance on on/off relay connector fused battery feed circuit (Red/Dark Blue wire). If resistance is less than 5 ohms, repair short to ground in Red/Dark Blue wire and replace "C" cartridge fuse. Perform VERIFICATION PROCEDURE VER-1.
  2. If resistance is more than 5 ohms, use DRB-II in ohmmeter mode to check resistance on on/off relay connector common drive circuit (Light Green/Black wire). If resistance is less than 5 ohms, repair short to ground in Light Green/Black wire and replace "C" cartridge fuse. Perform VERIFICATION PROCEDURE VER-1.
  3. If resistance is more than 5 ohms, disconnect windshield wiper motor connector. Connector is located on engine compartment firewall, just right of power brake booster. With DRB-II in ohmmeter mode, check resistance on high/low relay connector low speed output circuit (Brown/White wire). If resistance is less than 5 ohms, repair short to ground in Brown/White wire and replace "C" cartridge fuse. Perform VERIFICATION PROCEDURE VER-1.
  4. If resistance is more than 5 ohms, use DRB-II in ohmmeter mode to check resistance on high/low relay connector high speed output circuit (Red/Yellow wire). If resistance is less than 5 ohms, repair short to ground in Red/Yellow wire and replace "C" cartridge fuse. Perform VERIFICATION PROCEDURE VER-1. If resistance is more than 5 ohms, replace windshield wiper motor. Perform VERIFICATION PROCEDURE VER-1.
scientia non olet · About LEMON Manuals