LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 1993 >> Intrepid Base, 3.5 F >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - Body Control Computer >> Connector Identification >> Test 33A - Wiper Motor Intermittent Speed Operation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test 33A - Wiper Motor Intermittent Speed Operation

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  . For appropriate wiring diagram, see WIRING DIAGRAMS  at end of article.
  1. Move wiper switch through all 6 different delay (intermittent speed) levels. If all delay levels fail, go to step 3). If some or all delay levels operate properly, go to next step.
  2. Using DRB-II, read wiper switch status. Move wiper switch from OFF position through all 6 different delay levels. If DRB-II voltage does not increase proportionally between INTRMT WIPE: 0V and 5V (volts), replace multifunction switch. Perform VERIFICATION PROCEDURE VER-1. If DRB-II voltage does increase proportionally, replace body controller module. Perform VERIFICATION PROCEDURE VER-1.
  3. Turn wiper switch to off position. If wiper motor does not stop running, go to TEST 33B. If wiper motor does stop running, go to next step.
  4. Check if wipers park properly in off position. If wipers do not park properly in off position, go to TEST 33C  . If wipers park properly in off position, system is operating properly. Perform VERIFICATION PROCEDURE VER-1.
scientia non olet · About LEMON Manuals