LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 1993 >> Intrepid Base, 3.5 F >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - Body Control Computer >> Connector Identification >> Test 52B - Chime Feed Circuit
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test 52B - Chime Feed Circuit

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  . For appropriate wiring diagram, see WIRING DIAGRAMS  at end of article.
  1. With DRB-II in voltmeter mode, check voltage on feed side of fuse No. 5 (Red/Light Green wire). If voltage is less than 10 volts, repair open feed circuit. Perform VERIFICATION PROCEDURE VER-1.
  2. If voltage is more than 10 volts, disconnect headlight switch 7-pin connector from back of switch. Using an external ohmmeter, check resistance of parking light switch output circuit (Black/Yellow wire) between headlight switch connector and terminal No. 23 of Body Controller Module (BCM) Bone connector. If resistance is more than 5 ohms, repair open circuit in Black/Yellow wire. Perform VERIFICATION PROCEDURE VER-1. If resistance is less than 5 ohms, replace BCM. Perform VERIFICATION PROCEDURE VER-1.
scientia non olet · About LEMON Manuals