TEST 11A - Testing Headlight Switch For Courtesy Lamp Circuit
WARNING: This page is about a different car, the 1992 Dodge Dynasty, 1992 Chrysler New Yorker Fifth Avenue, 1992 Chrysler New Yorker, and 1992 Chrysler Imperial. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION . For wiring diagrams, see appropriate chassis wiring diagram in the WIRING DIAGRAMS Section.
- Remove headlight switch. Disconnect both headlight switch connectors. Check condition of connectors, and clean or repair connectors as necessary.
- Connect a jumper wire between terminal "D" (Yellow wire) of headlight switch 9-pin connector and Black wire of headlight switch 4-pin connector. If courtesy lights are on, replace headlight switch. Perform VERIFICATION TEST VER-1 . If courtesy lights are off, disconnect jumper wire.
- Connect a jumper wire between terminal "D" of headlight switch 9-pin connector and ground. If courtesy lights are on, repair open Black wire. Perform VERIFICATION TEST VER-1 . If courtesy lights are off, repair open Yellow wire. Perform VERIFICATION TEST VER-1 .