LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 1993 >> Intrepid Base, 3.5 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Engine Controls - Tests W/Codes - Body Control Computer) >> Self-Diagnostic Tests >> Test 14 - Ignition Key Light Circuit >> TEST 14A - Ignition Key Light Circuit
April 5, 2026: LEMON Manuals is launched! Read the announcement.

TEST 14A - Ignition Key Light Circuit

WARNING: This page is about a different car, the 1992 Dodge Dynasty, 1992 Chrysler New Yorker Fifth Avenue, 1992 Chrysler New Yorker, and 1992 Chrysler Imperial. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For wiring diagrams, see appropriate chassis wiring diagram in the WIRING DIAGRAMS Section.
  1. Ensure all doors are closed. Turn ignition switch to OFF position and wait one minute. If ignition key light is on constantly, perform TEST 14B . If ignition key light does not stay on constantly, turn ignition switch to ON position. Using DRB-II, actuate ignition key light test.
  2. If ignition key light flashes on and off, perform TEST 14C . If ignition key light does not flash on and off, stop ignition key light test using DRB-II. Disconnect ignition key light connector. See Fig 1. Put DRB-II in voltmeter mode.
    Fig 1: Ignition Key Light & Key in Ignition Connector
    G92G04831
    WARNING: If vehicle is equipped with air bag, air bag MUST be deactivated before servicing ignition key light bulb. See AIR BAG article in the ACCESSORIES/SAFETY EQUIPMENT Section.
  3. Probe terminal No. 4 (Pink/Light Blue wire) of ignition key light connector. If voltage is less than 10 volts, repair open Pink/Light Blue wire. Perform VERIFICATION TEST VER-1 . If voltage is more than 10 volts, remove ignition key light bulb. Inspect bulb and socket and repair or replace as necessary.
  4. If bulb and socket are okay, reinstall bulb and reconnect ignition key light connector. Turn ignition switch to OFF position. Disconnect body controller Black connector. Body controller is located behind right side kick panel. Check connector condition and repair or replace connector as necessary.
  5. Connect a jumper wire between terminal No. 22 (Yellow/Red wire) of body controller Black connector and ground. If ignition key light is off, repair open Yellow/Red wire. Perform VERIFICATION TEST VER-1 . If ignition key light is on, replace body controller. Perform VERIFICATION TEST VER-1 .
scientia non olet · About LEMON Manuals