Test 20E - Repairing Power Door Lock Problems W/ RKE
CAUTION:
Always turn ignition off prior to disconnecting or connecting any module connector.
- Remove door unlock relay (third relay from right, bottom row) from micro relay center, located behind center console. Using DRB in ohmmeter mode, check resistance of unlock relay output circuit (Pink/Black wire) at unlock relay connector. If resistance is more than 10 ohms, repair open Pink/Black wire. Perform TEST VER-1B . If resistance is less than 10 ohms, go to next step.
- Check resistance of both ground circuits (Black wires) at unlock relay connector. If resistance on either wire is more than 5 ohms, repair appropriate open Black wire. Perform TEST VER-1B. If resistance is less than 5 ohms on both wires, replace unlock relay. Perform TEST VER-1B.