LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 1994 >> Caravan Base, 2.5 K, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - Body Control Computer >> Self-Diagnostic Tests >> Test 39F - Repairing Right Turn Signal Circuit
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test 39F - Repairing Right Turn Signal Circuit

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION in this article. For wiring diagrams, see WIRING DIAGRAMS in this article.
CAUTION: Always turn ignition off prior to disconnecting or connecting any module connector.
  1. Turn ignition off. Disconnect Natural Body Control Module (BCM) connector. BCM is located behind center console. Turn ignition on. Go to next step.
  2. Using DRB in voltmeter mode, check voltage on right turn signal sense circuit (Tan wire) at Natural BCM connector terminal No. 14. If voltage is pulsing between zero and 10 volts, replace BCM. Perform TEST VER-1B. If voltage is not pulsing between zero volt and 10 volts, repair open in Tan wire. Perform TEST VER-1B.
scientia non olet · About LEMON Manuals