LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 1994 >> Dakota WS, 2.5 G >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Cruise Control System) >> Diagnostic Tests >> Test SC-1B - Checking Speed Control Operation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test SC-1B - Checking Speed Control Operation

WARNING: This page is about a different car, the 1995 Dodge Pickup and 1995 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition off. Disconnect brake switch 6-pin connector. Check connector for damaged, pushed out or miswired terminals. Repair as necessary. Perform VERIFICATION TEST SC-VER  . If connector is okay, turn ignition on. Press speed control switch on.
  2. With DRB in voltmeter mode, probe brake switch connector terminal No. 3, speed control on/off switch sense circuit (Yellow/Red wire). If voltage is less than 10 volts, repair open in Yellow/Red wire. Perform VERIFICATION TEST SC-VER  .
  3. If voltage is greater than 10 volts, turn ignition off. Using an ohmmeter, check resistance of brake switch connector terminal No. 4, speed control brake switch output circuit (Dark Blue/Red wire). If resistance is greater than 5 ohms, repair open in Dark Blue/Red wire. Perform VERIFICATION TEST SC-VER  . If resistance is less than 5 ohms, replace brake switch. Perform VERIFICATION TEST SC-VER  .
scientia non olet · About LEMON Manuals