Test 44B - Repairing Washer Pump Problem

WARNING: This page is about a different car, the 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagram, see WIRING DIAGRAMS . Perform TEST VER-1 after each repair.

Turn ignition switch to OFF position. Put DRB in ohmmeter mode. Measure resistance at washer pump connector terminal No. 2 (Black wire). If resistance is more than 5 ohms, repair open in Black wire. If resistance is less than 5 ohms, replace washer pump motor.