LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 1994 >> Intrepid Base, 3.3 U >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - Body Control Computer >> Self-Diagnostic Tests >> Test 42A - Repairing Courtesy Lamp Inputs
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test 42A - Repairing Courtesy Lamp Inputs

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  . For wiring diagrams, see WIRING DIAGRAMS  . Perform TEST VER-1 after each repair.
CAUTION: Always turn ignition switch to OFF position prior to disconnecting any module connector.
  1. Ensure all doors are aligned correctly against switches. If doors are misaligned or misadjusted, align or adjust door(s) as necessary. Ensure courtesy lamp switch (located next to headlamp switch) is off. Ensure all doors are closed. Go to next step.
  2. Using DRB, read left front door ajar switch status. If DRB displays LFDOOR AJAR CLOSED, go to TEST 44A  . If DRB does not display LFDOOR AJAR CLOSED, go to next step.
  3. Using DRB, read door ajar switch status. If DRB displays DOOR AJAR CLOSED, go to TEST 45A  . If DRB does not display DOOR AJAR CLOSED, go to next step.
  4. Using DRB, read courtesy lamp switch status. If DRB displays COURTESY SW CLOSED, go to TEST 46A  . If DRB does not display COURTESY SW CLOSED, check if vehicle is equipped with Remote Keyless Entry (RKE) module. See Figure . If vehicle is equipped with RKE module, go to step 6). If vehicle is not equipped with RKE module, go to next step.
  5. Turn ignition switch to OFF position. Disconnect Body Control Module (BCM) connectors. BCM is located on behind right kick panel. If courtesy lamps go off, replace BCM. If courtesy lamps remain on, repair short to ground in Yellow wire.
  6. Ensure all doors are closed. Turn ignition switch to OFF position. Disconnect RKE module connector. If courtesy lamps go off, replace RKE module. If courtesy lamps remain on, go to next step.
  7. Disconnect Body Control Module (BCM) Gray connector. BCM is located behind right kick panel. If courtesy lamps go off, repair short to ground in White wire. If courtesy lamps remain on, go to next step.
  8. Disconnect BCM Bone connector. If courtesy lamps go off, replace BCM. If courtesy lamps remain on, repair short to ground in Yellow wire.