Test 41D - Repairing Door Lock Problem

WARNING: This page is about a different car, the 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagram, see WIRING DIAGRAMS . Perform TEST VER-1 after each repair.

CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.

Gain access to inoperative door lock switch connector. Put DRB in voltmeter mode. With connector connected, measure voltage at switch connector terminal No. (Red wire). If voltage is less than 10 volts, repair open Red wire. If voltage is more than 10 volts, replace door lock switch.