LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 1994 >> Intrepid Base, 3.5 F >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Computer >> Testing >> Test 40A - Right Front Door Ajar Circuit
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test 40A - Right Front Door Ajar Circuit

NOTE: Perform TEST 34A  or 93A before proceeding with this test. For connector terminal ID, see CONNECTOR IDENTIFICATION  . For wiring schematics, see WIRING DIAGRAMS  in this article. Perform TEST VER-1 - VERIFICATION PROCEDURE  after each repair.
CAUTION: Always turn ignition off prior to disconnecting any module connector.
  1. Disconnect right front door ajar switch connector. Check right front door ajar switch connector ground strap for damage or corrosion. Repair ground strap as necessary. If ground strap is okay, go to next step.
  2. Connect jumper wire between ground and Tan/Red wire on right front door ajar switch connector. Using scan tool, read door ajar switch status. If scan tool displays DOOR AJAR: CLOSED, replace right front door ajar switch. If scan tool does not display DOOR AJAR: CLOSED, go to next step.
  3. Disconnect jumper wire. Gain access to Body Control Module (BCM). BCM is located behind right kick panel. Connect jumper wire between ground and terminal No. 3 Tan/Red wire on BCM Gray connector. Using scan tool, read door ajar switch status. If scan tool displays DOOR AJAR: CLOSED, repair open Tan/Red wire. If scan tool does not display DOOR AJAR: CLOSED, replace BCM.
scientia non olet · About LEMON Manuals