LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 1994 >> Intrepid Base, 3.5 F >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - Body Control Computer >> Self-Diagnostic Tests >> Test 36A - Power Door Lock & Remote Keyless Entry Problem Id
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test 36A - Power Door Lock & Remote Keyless Entry Problem Id

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  . For wiring diagrams, see WIRING DIAGRAMS  . Perform TEST VER-1 after each repair.
  1. Lower both front windows. Remove key from ignition switch. Close all doors. Lock and unlock doors from both front door switches. If doors fail to lock or unlock properly, perform appropriate test listed in TEST 36A DIAGNOSTIC DIRECTORY table. If doors lock and unlock properly, go to next step.
    TEST 36A DIAGNOSTIC DIRECTORY

    Problem Perform Test No.
    All Doors Fail To Lock & Unlock From Any Switch TEST 35B 
    One Door (1) Fails To Lock & Unlock From Any Switch TEST 35D 
    All Doors Fail To Lock & Unlock From One Switch TEST 35E 
    All Doors Fail To Lock From Any Switch TEST 35F 
    All Doors Fail To Lock From One Switch (2) *
    All Doors Fail To Unlock From Any Switch TEST 35H 
    All Doors Fail To Unlock From One Switch (2) *
    Left Front Door Fails To Lock & Unlock From Any Switch TEST 36B 
    Left Front Door Fails To Lock From Any Switch TEST 36C 
    Left Front Door Fails To Unlock From Any Switch TEST 36D 
    All Doors (1) Fail To Lock & Unlock TEST 36E 
    All Doors (1) Fail To Lock TEST 36F 
    All Doors (1) Fail To Unlock TEST 36G 
    (1) Except left front door.
    (2) Replace defective switch.
  2. Using Remote Keyless Entry (RKE) transmitter, operate door locks and trunk lock. If door locks and trunk lock do not operate properly, replace transmitter batteries or substitute a known-good transmitter. If RKE transmitter still does not operate properly, go to TEST 36H  . If RKE transmitter operates properly, go to next step.
  3. Insert key in ignition switch. Open left front door. Lock doors from either switch. If doors lock with key in ignition switch, go to TEST 35J  . If doors do not lock with key in ignition switch, go to next step.
  4. If vehicle is equipped with speed sensitive locks, drive vehicle with all doors closed. Reach a vehicle speed more than 15 MPH. If doors do not lock at more than 15 MPH, go to TEST 35K  . If doors lock, system is operating properly at this time.