Entering On-Board Diagnostics: Notes
WARNING: This page is about a different car, the 1993 Dodge Dynasty, 1993 Chrysler New Yorker Fifth Avenue, 1993 Chrysler New Yorker, and 1993 Chrysler Imperial. However, it is still accessible from the selected car via links, so may be relevant.
- Before entering on-board diagnostics, refer to PRETEST INSPECTION . Turn ignition off. Attach appropriate 1993 cartridge to DRB-II. Connect DRB-II to CCD bus diagnostic connector. See Figure .
- Turn all accessories off. Turn ignition on. All character positions will glow and copyright information will appear on DRB-II screen for a few seconds. Display will then change to DRB-II menu.
- If DRB-II displays an error message or if screen is blank, refer to BODY CONTROL COMPUTER - VEHICLE COMMUNICATIONS tests. Always start at TEST 1A: FAULT MESSAGES.
- The following DRB-II modes can be accessed from DRB-II menu: VEHICLES TESTED, HOW TO USE, CONFIGURE and SELECT SYSTEM.