Test 14B - Ignition Key-In Light Circuit

WARNING: This page is about a different car, the 1993 Dodge Dynasty, 1993 Chrysler New Yorker Fifth Avenue, 1993 Chrysler New Yorker, and 1993 Chrysler Imperial. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For appropriate wiring diagram, see WIRING DIAGRAMS at end of article.

Turn ignition off. Disconnect Body Control Module (BCM) Black connector. BCM is located behind right side kick panel. If ignition key-in light goes out, go to TEST 14C. If ignition key-in light stays on, repair short to ground in Yellow/Red wire. Perform VERIFICATION PROCEDUREVER-1.