Test 15D - OTIS Estimated Time Problem

WARNING: This page is about a different car, the 1993 Eagle Vision, 1993 Dodge Intrepid, and 1993 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For appropriate wiring diagram, see WIRING DIAGRAMS at end of article.

Turn ignition off. Disconnect Body Controller Module (BCM) Bone connector. Module is located behind right kick panel. With DRB-II in voltmeter mode, check voltage on BCM Bone connector terminal No. 13, ignition feed (run) circuit (Dark Blue/White wire). Turn ignition on. If voltage is more than 10 volts, replace BCM. Perform VERIFICATION PROCEDURE VER-1. If voltage is less than 10 volts, repair open circuit in Dark Blue/White wire. Perform VERIFICATION PROCEDURE VER-1.