Test 33D - Wiper Motor Control Circuit

WARNING: This page is about a different car, the 1993 Eagle Vision, 1993 Dodge Intrepid, and 1993 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For appropriate wiring diagram, see WIRING DIAGRAMS at end of article.

Disconnect multifunction switch connector. Connector is located on upper part of steering column, behind trim cover. If wiper motor stops operating, replace multifunction switch. Perform VERIFICATION PROCEDURE VER-1. If wiper motor does not stop operating, replace body controller module. Perform VERIFICATION PROCEDURE VER-1.