Test 36C - Remote Keyless Entry (RKE) Door Lock Relay Problem
WARNING: This page is about a different car, the 1993 Eagle Vision, 1993 Dodge Intrepid, and 1993 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION
. For appropriate wiring diagram, see WIRING DIAGRAMS
at end of article.
- Turn ignition off and disconnect Body Controller Module (BCM) Bone connector. Module is located behind right kick panel. Check voltage on BCM Bone connector terminal No. 9, power door lock switch circuit (Orange/Violet wire). Depress opposite (passenger's) door switch to lock position. If voltage is less than 10 volts, repair open circuit in Orange/Violet wire. Perform VERIFICATION PROCEDURE VER-1.
- If voltage is more than 10 volts, turn ignition off and reconnect BCM Bone connector. Turn ignition on and press door lock switch to lock position. If doors do not lock, replace BCM. Perform VERIFICATION PROCEDURE VER-1. If doors lock, problem is in driver's door. Repair wiring.