Test 49B - Headlight Switch Fused Output Circuit Short

WARNING: This page is about a different car, the 1993 Eagle Vision, 1993 Dodge Intrepid, and 1993 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For appropriate wiring diagram, see WIRING DIAGRAMS at end of article.

Disconnect Body Controller Module (BCM). Module is located behind right kick panel. With DRB-II in voltmeter mode, check voltage on BCM Bone connector terminal No. 3, headlight switch fused output circuit (Red/Light Green wire). If voltage is more than 10 volts, repair short to battery in Red/Light Green wire and replace fuse No. 5. Perform VERIFICATION PROCEDURE VER-1.
If voltage is less than 10 volts, use DRB-II in ohmmeter mode to check resistance on BCM Bone connector terminal No. 3, headlight switch fused output circuit (Red/Light Green wire). If resistance is less than 5 ohms, repair short to ground in Red/Light Green wire and replace fuse No. 5. Perform VERIFICATION PROCEDURE VER-1. If resistance is more than 5 ohms, replace BCM. Perform VERIFICATION PROCEDURE VER-1.